Ritron Quick Talk Owner's Manual download pdf (Page 20)

Page 18

For assistance, call RITRON at 800-872-1872, or go to www.ritron.com

10. SETTING BATTERY SAVER

OPTIONS

TO SET BATTERY SAVER OPTIONS:

The Battery Saver factory default is "Battery Saver enabled."

In this setting, which greatly extends battery life, Quick Talk

checks switch inputs for changes 4 times a second.

a. Dial "932" to enable Battery Saver.

NOTE: DO NOT disable the Battery Saver unless you

need to detect very fast changes in the switch

inputs.

To detect very fast changes, set Quick Talk to check switch

inputs rapidly:

b. Dial "931" to disable Battery Saver.

NOTE: Powering the Quick Talk with an external Power

Supply is very practical with the Battery Saver

Option disabled, because Quick Talk draws

approximately 7 mA continuously with this setting.

9. ENABLE/ DISABLE

STATUS MESSAGES

TO DISABLE LOW BATTERY MESSAGE:

a. Pick up the telephone receiver and listen for the

acknowledge tone.

b. Dial "941".

TO ENABLE LOW BATTERY MESSAGE:

a. Pick up the telephone receiver and listen for the

acknowledge tone.

b. Dial "942".

NOTE: The default is Low Battery Message On.

TO DISABLE EXTERNAL POWER FAILURE MESSAGE:

a. Pick up the telephone receiver and listen for the

acknowledge tone.

b. Dial "951".

TO ENABLE EXTERNAL POWER FAILURE MESSAGE:

a. Pick up the telephone receiver and listen for the

acknowledge tone.

b. Dial "952".

NOTE: The default is Power Failure Message

Off.

8. RECORDING UNIQUE

POWER FAILURE MESSAGES

What is the purpose of recording a unique Voice

Phrase for the Power Failure Message? When it senses

power failure, Quick Talk transmits a factory-programmed

"Power Failure" message no more often than once an hour.

If you have several units grouped within radio range of one

another, we recommend you customize messages to easily

identify the specific unit.

NOTE:Also physically mark the Quick Talk case with the

same unique identifier (number) you record for

Quick Talk location phrasing (see page 13).

Do I need to program this feature? If you use only one

Quick Talk in an area, or if you regularly change Quick Talk

batteries, the factory-programmed message may be

sufficient: you can skip to the next section.

TO RECORD POWER FAILURE PHRASE:

a. Pick up the telephone receiver and listen for the

acknowledge tone.

b. Dial "34"Quick Talk prompts you with three short

tones to begin speaking.

NOTE: Your recorded POWER FAIL phrase is to be

no longer than 1.5 seconds.

EXAMPLE: "Power fail fivec. Hang up the telephone

when you are done speaking.

d. To review the POWER FAIL phrase, dial "44".

e. Repeat steps "a" through "d" until you are pleased with

the results.

UICK

ALK

DV ANCED

EATURES

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Ritron Quick Talk Owner's Manual Page 20

Comments to this Manuals

Related products and manuals for Car video systems Ritron Quick Talk